RF Output Spectrum
Table 5. Electrical Characteristics (continued)
Limits
Parameter
Test Conditions, Comments
Unit
Min.
Typ.
Max.
2.41 Data to RF delay difference between
MODE = 0, see note
3.5
5.25
7.5
μs
2.42
falling and rising edges,
t delay_difference
MODE = 1, see note
–200
200
ns
Note: This parameter is depending on crystal characteristics, load capacitor values (see Table 4 ) and PCB track capacitance.
Note: Delay difference definition
Input data
Demodulated data
3
t delay_rise
From 50% of data edge to corresponding
demodulated signal envelope edge:
t delay_difference = t delay_fall – t delay_rise
t delay_fall
Microcontroller Interfaces
3.1
3.2
3.3
3.4
3.5
3.6
3.7
3.8
3.9
3.10
Input low voltage
Input high voltage
Input hysteresis voltage
Input current
ENABLE pulldown resistor
DATACLK output low voltage
DATACLK output high voltage
DATACLK rising time
DATACLK falling time
DATACLK settling time,
t DATACLK_settling
Pins: BAND, MODE, ENABLE, and DATA
Pins: BAND, MODE,DATA = 1
C load = 2 pF
C load = 2 pF, measured from 20% to 80% of the
voltage swing
45% < duty cycle f DATACLK < 55%
0
0.7 x
V CC
0
0.75 x
V CC
180
250
150
800
0.3 x
V CC
V CC
120
100
0.25 x
V CC
V CC
500
400
2000
V
V
mV
nA
k Ω
V
V
ns
ns
μs
10
RF Output Spectrum
The following figures represent spectrums of the transmitter carrier, measured in conduction mode. Three different spans have
been used. The 5 MHz span spectrum ( Figure 5 ) shows phase noise response close to the RF carrier and the noise suppression
within the PLL-loop bandwidth. The 50 MHz span spectrum ( Figure 6 ) shows phase noise and reference spurious. Finally, the
1.5 GHz span spectrum ( Figure 7 ) shows the second and third harmonics of carrier. All spectrums are measured in OOK
modulation at DATA=1.
Figure 8 shows the spectrum in case of FSK modulation with 45 kHz deviation at 4 kbit/s data rate.
PLL Tuned UHF Transmitter for Data Transfer Applications, Rev. 1.7
10
Freescale Semiconductor
相关PDF资料
MC33591MOD315EV BOARD EVAL MC33493 TANGO3 RF
MC33593MOD868EV BOARD EVAL MC33593 ROMEO2 RF
MC33690DWER2 IC STAND ALONE TAG READER 20SOIC
MC44CC375AVEFEVK CCEVK NEJA EVAL KIT
MCH3374-TL-E MOSFET P-CH 12V 3A MCPH3
MCH3375-TL-H MOSFET P-CH 1.6A 30V MCPH3
MCH3377-TL-E MOSFET P-CH 20V 3A MCPH3
MCH3377-TL-H MOSFET P-CH 3A 20V MCPH3
相关代理商/技术参数
MC3350-041-91 制造商:SPC Multicomp 功能描述:ROCKER SWITCH DPDT CTR OFF 制造商:SPC Multicomp 功能描述:ROCKER SWITCH, DPDT, CTR OFF 制造商:SPC Multicomp 功能描述:SWITCH, ROCKER, DPDT, 15A, 250V, BLACK; Contact Configuration:DPDT; Switch Operation:On-Off-On; Contact Current Max:10A; Contact Voltage AC Nom:250V; Contact Voltage DC Nom:250V; Switch Mounting:Panel; Actuator / Cap Color:Black ;RoHS Compliant: Yes
MC3350-041-91 制造商:SPC Multicomp 功能描述:SWITCH ROCKER DPDT CTR OFF
MC33501SNT1 功能描述:运算放大器 - 运放 1-7V Single Rail to RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比(最小值):63 dB 输入补偿电压:1 mV 输入偏流(最大值):10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel
MC33501SNT1G 功能描述:运算放大器 - 运放 1-7V Single Rail to Rail -40 to 105 Cel RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比(最小值):63 dB 输入补偿电压:1 mV 输入偏流(最大值):10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel
MC33501SNT1G 制造商:ON Semiconductor 功能描述:OP AMP SINGLE R/R SMD SOT23-5
MC33501SNT1GH 制造商:Rochester Electronics LLC 功能描述: 制造商:ON Semiconductor 功能描述:
MC33502D 功能描述:运算放大器 - 运放 1-7V Dual Rail to RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比(最小值):63 dB 输入补偿电压:1 mV 输入偏流(最大值):10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel
MC33502DG 功能描述:运算放大器 - 运放 1-7V Dual Rail to Rail -40 to 105 Cel RoHS:否 制造商:STMicroelectronics 通道数量:4 共模抑制比(最小值):63 dB 输入补偿电压:1 mV 输入偏流(最大值):10 pA 工作电源电压:2.7 V to 5.5 V 安装风格:SMD/SMT 封装 / 箱体:QFN-16 转换速度:0.89 V/us 关闭:No 输出电流:55 mA 最大工作温度:+ 125 C 封装:Reel